osmm.net
  • OSMM@HK
    • OSMM.NET
    • Academia
    • Learn 3D CG
    • 3D Printing Info.
    • Learn 2D CG
  • Tutorials
    • Blender 2.9X Interface
    • Blender 2.8x Modelling
    • SITCON HK 2018
    • HK SIGGRAPH 18
    • Maker Faire 2017
    • HK Maker Club WS
    • I MAKE 08 Workshop
    • I MAKE 07 Workshop
    • I MAKE 06 Workshop
    • I MAKE 05 Workshop
    • I MAKE 04 Workshop
    • I MAKE 03 Workshop
    • I MAKE 02 Workshop
    • I MAKE 01 Workshop
  • Events
    • WBMD2022
    • HKOSCon2021
    • ACAS2021
  • Open Resources
    • ✍【電腦影像創作人 ..】
    • 3D Files
    • Sketchfab
  • Contact Us

Important Notes from our industrial centre


Recommendation on Z-Copr 3D Printing

  1. Blender model should be converted to STL format for 3D printing, the STL file should be checked and fixed before production. Try NOT to output your STL file into too high resolution, the file size should be keep less than 10MB
  2. Check the Center of Gravity of your model, add the "BaseTemplate.blend" part before converting to STL format
  3. Minimum thickness for all parts should be kept around 2-3mm
  4. Avoid sharp edges in the design; add at least 0.5mm fillet to round all sharp edges if necessary
  5. While building a bulk solid, it is recommended to hollow the bold parts and the shell thickness should be keep within 3-4mm. Besides, a 4-5mm hole is needed for powder removal

Safety Instructions for the IC Seminar & Visit at w501 (19/July) 

RAPID PROTOTYPING & TOOLING WORKSHOP SAFETY INSTRUCTIONS
  1. You must wear safety shoes and appropriate gloves, apron, goggles in the IC workshop area
  2. Eating and drinking is NOT allowed
  3. You should not operate any machine unless you are authorized to do so
  4. Do not play and run inside the IC workshop area
  5. You must wear eye protective gear when using compress air gun
  6. Report immediately for any accident to our staff
  7. Keep tools and equipment in the proper racks when not in use
  8. Keep the workplace clean and dry
  9. Smoking is NOT allowed under all circumstances
  10. Keep all chemical containers fully closed after using

Special precautions when working with Z-Corp. 3-D printing machine

Plaster and starch based powder are being used in the Z-Corp. 3-D printing machine, both powder are stable and without hazards to human body. However, excessive exposure can result in irritation of the eyes, nose, skin, and/or lungs. Dust may cause coughing, sneezing or basal irritation. Therefore, respirator and safety goggle must be worn during the part removal operation.


Powered by Create your own unique website with customizable templates.